Automatic Pump and Hand Pump for 3D Printer Filament Storage Vacuum Sealer Bag, Suction Pump

ATTENTION PLEASE:
Our pumps suitable for food and 3D printing filament vacuum storage bags, which with flat air valves.

DO NOT suitable for clothing storage bags with protruding air valves.

Automatic Pump

Vacuum:Decompression and hypoxia sealing
Moisture-proof:Vacuum moisture proof andmildew proof
Valtage: 5V
Power: 3W

How to Use

There is a soft rubber circle at the bottom of the pump, please align this circle with the air valve of the bag. Make sure there are no gaps between the pump and the bag.

In the first 15-30 seconds, you may find that there is no change in the sealed bag, which is because there is too much air in the bag, so the change is not significant. Please continue to draw air, and after 30 seconds, the bag will shrink significantly until the air is completely drawn out, then you can stop

Power of Auto Pump

Vacuum suction: 50-60Kpa
It will take 30-60 seconds for 1kg PLA vacuum bag

Attention please, the vacuum bags are not included.

Rechargeable

Built-in battery.
Comes with a type C usb cable, you can charge it throught Notebook or any other mobile phone charger with 5V 1A output.

Charge Time: 1 hour
Red light: Charging
Blue light: Fully charge.

No Fast Charging

Please confirm if your charging device and charging method are correct.

The pump comes with a black cable, you can charge it through Notebook or any other mobile phone charger with 5V 1A output. Do not charge it by fast charger and type C- type-C cable.

Hand/ Manual Pump

How to Use

It will take 1-2 minutes for 1kg PLA vacuum bag

Attention please: In the first 30 seconds, you will feel a lot of resistance, please do not hesitate to continue pulling, as sufficient suction is needed to activate the air valve port. And after 30 seconds, the bag will shrink significantly until the air is completely drawn out, then you can stop vacuuming.

Pump Only

Attention please, the vacuum bags and filament are not included.